Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterAbatement Technologies Air Quality & Sanitizing in Aurora: What to Know First
We provide independent Abatement Technologies air quality and sanitizing in Aurora, from mold treatment and bacteria sanitizing to UV light installation and whole-home air purifier integration. Most Abatement Technologies jobs in Aurora are scheduled within a few days, and every one starts with a written flat price before any work begins - Haven Standard Clause 1. Typical whole-system air quality service for an Abatement Technologies setup in Aurora runs $340-$780 depending on the scope, with no per-vent add-ons or post-arrival surprises.
This page is for Aurora homeowners who already have Abatement Technologies equipment - PREDATOR portable air scrubbers, HEPA-AIRE filtration systems, or CAP600/ CAP1200 central units - and need sanitizing, odor removal, or allergen reduction that actually gets documented. We also service Lennox, Trane, and Carrier systems when a home has mixed equipment. Call (720) 513-5159 for a free estimate and we’ll put the number in writing before we schedule.
How Abatement Technologies Products Fail - and How We Fix Them
- PREDATOR 750 and 1200 series portable scrubbers: The carbon pre-filters in these units saturate faster than owners expect in Aurora’s semi-arid climate, where spring dust storms load particulate matter in concentrations that overwhelm standard 12-inch pleats. We see this every May in homes near the Rocky Mountain Arsenal. Our fix is a documented filter load test - we photograph the pre-filter against a light sheet - then replace with OEM-spec media or upgrade to extended-surface pleats if the job site justifies it. The photo goes in your job record.
- HEPA-AIRE SAH2 and SAH4 negative air machines: The blower motors on these units develop imbalance after roughly 1,800-2,200 runtime hours because Aurora’s hard water mineral content deposits on the shaft bearings during humidifier season. The symptom is a low-frequency vibration that gets mistaken for “normal operation.” We pull the HEPA, check runout with a dial indicator, and replace the motor mount assembly if the spec is out. We only use OEM motor kits on these - aftermarket mounts don’t seat the same and void the remaining warranty.
- CAP600 central air purifiers with UV-C add-ons: The 16-inch UV lamps lose output curve faster than the 12-month replacement interval suggests, especially in Aurora homes with south-facing mechanical rooms where attic heat pushes ambient temperature above 85°F for weeks each summer. A lamp that still “glows” can be below 40 µW/cm² at one meter, which is the threshold for effective DNA disruption in mold and bacteria. We meter every UV install with a radiometer and show you the reading. If it’s below spec, we replace and log the serial number.
- Abatement Technologies Guardian R500 odor oxidizers: The titanium dioxide catalyst plates in these units accumulate a film of volatile organic compounds that reduces hydroxyl generation by 30-50% after 18 months in Aurora homes with gas cooktops. The unit runs, but it’s making noise, not chemistry. We pull the catalyst assembly, photograph the film buildup under LED, and either ultrasonic-clean or replace depending on porosity. This is a detail Abatement Technologies’ own documentation treats as “periodic maintenance” without defining the interval - we’ve settled on 14 months based on what the photo record shows.
- PREDATOR 400 series with HEPA final filters: The gasket seal between the HEPA frame and the cabinet warps in low-humidity winter conditions common to Aurora’s January-February stretch. The symptom is a bypass whistle on startup that disappears after 30 seconds - owners ignore it, but it means unfiltered air is being pushed through the outlet. We replace the gasket with silicone-foam spec, torque the frame to 15 in-lb, and pressure-test the seal with a smoke pencil. The test result is photographed and included in your deliverables.
Our Abatement Technologies Air Quality & Sanitizing Process
- 1
System inventory and photo baseline. We photograph the equipment nameplate, filter condition, and any visible contamination before touching anything. This is your “before” record - we don’t start work until you’ve seen it.
- 2
Written scope and flat price. Based on what we find, we deliver a written scope with one flat price for the complete job. Haven Standard Clause 1: no work starts without your signature on that price. If you have a competitor’s written estimate, we provide a free second opinion and put our number next to it.
- 3
Component-level service. We service or replace filters, UV lamps, catalyst assemblies, and seals using OEM or verified-equivalent parts - we name the manufacturer on the invoice so you can verify independently. For Abatement Technologies equipment, we stock PREDATOR filter kits and CAP600 UV lamps; specialty items we source with a 24-48 hour turnaround.
- 4
Performance verification. Every sanitizing job gets a post-service airflow check at the register, UV output measurement where applicable, and a pressure test on sealed assemblies. The numbers are logged, not estimated.
- 5
Documented photo record and 365-Day Done Right Promise. We deliver before-and-after photos of every duct run and equipment cavity, plus the written scope and invoice, as your permanent job record. If anything isn’t right within 365 days, we make it right - in writing, not as a favor.
BeforeAfterWhat Abatement Technologies Air Quality & Sanitizing Costs in Aurora
| Service | Typical Range | What Moves the Price |
|---|---|---|
| PREDATOR portable scrubber filter replacement and sanitizing | $180-$290 | Number of filter stages, HEPA vs. ULPA spec, whether the blower needs rebalancing |
| CAP600/CAP1200 UV lamp replacement and output verification | $240-$380 | Lamp length (16″ vs. 24″), accessibility of the plenum mount, whether the ballast tests within spec |
| Whole-system bacteria/mold sanitizing with negative-pressure extraction | $420-$780 | Home size (duct run count), contamination severity per photo evidence, whether Guardian oxidizer integration is included |
| Guardian R500 catalyst cleaning or replacement | $195-$340 | Ultrasonic clean vs. full replacement, film thickness per borescope measurement |
| HEPA-AIRE blower motor mount replacement | $280-$450 | OEM motor kit vs. verified equivalent, whether shaft runout requires full motor replacement |
These are whole-system prices - no per-vent charges, no equipment fees added after arrival. The price we write is the price you pay. Call (720) 513-5159 for an exact quote; estimates are free and we put them in writing before you decide.
Why Aurora Homeowners Call CleanRun Air Duct Cleaning Aurora for Abatement Technologies Work
We’ve been running jobs in Aurora since 2013 - from the older ranch homes near Aurora Hills Golf Course where Abatement Technologies portables get deployed during remodels, to the new construction along E-470 where CAP600 units are spec’d by the builder. Tomas Reyes, our owner and lead technician, keeps every before-and-after photo himself. His approach is simple: show you the photo first, then we talk about what comes next.
The 365-Day Done Right Promise applies to every Abatement Technologies job we touch. Our technicians are background-checked, uniformed, and identified by name before arrival - Haven Standard Clause 3: Verified Crews. We also maintain full capability on Lennox, Trane, and Carrier systems, which matters when your home has mixed equipment or when an Abatement Technologies install interfaces with a different-brand air handler. License number is published on every estimate; we’re not hard to verify.
FAQs
Will servicing my Abatement Technologies equipment void the warranty?
No - warranty coverage remains intact when service is performed by a qualified technician using OEM or equivalent-spec parts. We document every part serial number and service step so you have a record if a warranty question ever arises. As an independent Abatement Technologies service provider, we are not affiliated with the manufacturer, but we follow their published service specifications precisely. Call (720) 513-5159 if you want us to review your warranty status before scheduling.
How do I know the sanitizing work was actually done?
Every job includes a Documented Photo Record of every duct run and equipment cavity, plus post-service performance readings where applicable - UV output in µW/cm², airflow in CFM, pressure test results. You receive these as standard deliverables, not upon request. If a company won’t show you the inside of your own ducts, they didn’t clean them.
Why are some Abatement Technologies service quotes so much cheaper?
The low quotes usually involve filter swaps without performance verification, or “sanitizing” that is fogging without source removal. A real Abatement Technologies service job includes component inspection, measurable output testing, and photo documentation. We quote the full scope in writing so you can compare apples to apples. Our free second opinion service will put our written number next to any competitor’s quote.
Should I repair my Abatement Technologies unit or replace it?
Most Abatement Technologies central units have a 15-20 year service life if maintained; portables typically run 8-12 years depending on runtime hours. We recommend replacement when repair costs exceed 40% of replacement value and the unit is past 75% of expected lifespan. We give you both numbers in writing and let you decide - no pressure, no urgency theater.
How often does Abatement Technologies air quality equipment really need service in Aurora?
For Aurora’s climate - dry winters, dusty springs, high UV load in summer - we see optimal results with annual filter service on central units, 14-month catalyst inspection on Guardian oxidizers, and UV output verification every 12 months. PREDATOR portables used in construction or remediation should be serviced after every major project or 6 months of continuous use, whichever comes first. Call (720) 513-5159 and we’ll build a schedule to your actual usage, not a calendar generic.
Written by Tomas Reyes, Owner & Lead Technician, CleanRun Air Duct Cleaning Aurora at CleanRun Air Duct Cleaning Aurora, serving Aurora and nearby areas.